Reply To: New Trailing Stop Tool

Optuma Forums Feature Requests New Trailing Stop Tool Reply To: New Trailing Stop Tool

#58201
MathewMathew
  • Topics: 28
  • Replies: 1,335
  • Posts: 1,363

Show Stop Tool

Has properties:
– Interval Script which has the calculation eg ATR()
– Calculate From : Open|High|Low|Close|HL|HLC|OHLC|Median (where we measure the interval from)
– Ratchet On|Off
– Reset Bars
– Stop On : Any|Open|High|Low|Close|HL|HLC|OHLC|Median (what crossing the line will trigger the stop)
– Continuous : This means it is one continuous line like a PSAR tool

If not continuous, it starts from the selected point and has a label at the point is was broken.

Pin It on Pinterest

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close