Reply To: Negative to Positive

Optuma Forums Optuma Scripting Negative to Positive Reply To: Negative to Positive

#59928
MatthewMatthew
  • Topics: 5
  • Replies: 292
  • Posts: 297

If the autoscale is enabled on the scale properties it should auto set the zone to the min / max values in view.  If autoscale is off you will see a padlock icon at the top of the tools scale, clicking it will re-enable autoscale.

Ex2

If autoscale is on and there’s empty space, it means there is a tool or value somewhere that is causing the scale to adjust, so it fits into view. (Sometimes this can be an overlaid tool in the same view, even if it is hidden).

Pin It on Pinterest

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close