Reply To: IF Statement

Optuma Forums Optuma Scripting IF Statement Reply To: IF Statement

#60325
MathewMathew
  • Topics: 29
  • Replies: 1,474
  • Posts: 1,503

I’ve not read all of this – too late in the day for that much reading!

But I did see that your switch code is wrong – pay attention to the > symbol as I said in my last post.

Var4 = SWITCH(Var3 >= 0.3, Var3 <= -0.3);

Pin It on Pinterest

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close