Select Page

Reply To: CAD() > its centerline

Optuma Forums › Optuma Scripting › CAD() > its centerline › Reply To: CAD() > its centerline

January 7, 2021 at 8:00 pm #61969
DarrenDarren
  • Topics: 62
  • Replies: 523
  • Posts: 585

The centreline has a value of zero so it would be CAD() > 0, or CAD() CrossesAbove 0 for a signal.

Pin It on Pinterest

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close