Reply To: A few scripting questions

Optuma Forums Optuma Scripting A few scripting questions Reply To: A few scripting questions

#65319
Andrew
  • Topics: 1
  • Replies: 3
  • Posts: 4

I am trying to write a script and don’t know if it is possible.  I have the oscillator line in MACD set at 5. I am trying to write a script that essentially says the oscillator line is ticked upwards or angled upwards and above the zero line. Does not need to cross the zero line just angled up and above it. I have tried several combinations of the following but without any success. Does anyone have any ideas to help

MACD()TYPE=oscilator BAR1=5 angled up greater than 0.00

thanks

andrew

Pin It on Pinterest