Reply To: Show Bar View Problem

Optuma Forums Optuma Scripting Show Bar View Problem Reply To: Show Bar View Problem

#66927
Darren
  • Topics: 70
  • Replies: 802
  • Posts: 872

Thanks Donald. A couple of points:

You are missing a few () – ie OFFSET(high, OFFSET=1) should be OFFSET(high(), OFFSET=1)

Another way of doing offsets is using square brackets, so the previous high value can be found using HIGH()[1]

Also, ‘mid’ is not a value we calculate. So CLOSE()>OFFSET(mid, OFFSET=2) should be

1 user thanked author for this post.

Pin It on Pinterest