Draw Channel Lines

Optuma Forums Optuma General Discussion Draw Channel Lines

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #59093
    AvatarMay
    • Topics: 12
    • Replies: 17
    • Posts: 29

    I can draw a trend line in a log-scale chart.  But I am unable to draw the channel lines in the same as it has no log-adjust properties.  Same for Gann fan angles.

    Kindly advise if there is an alternative way to draw them.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close