Manual Lists

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #64617
    deepak
    • Topics: 50
    • Replies: 35
    • Posts: 85

    Hiii Sir,

    Is it possible to connect a manual list or a csv list to custom exchange in back tester or signal tester or in a watch list.

    Regards,
    Deepak

    #64625
    Darren
    • Topics: 66
    • Replies: 617
    • Posts: 683

    Hi Deepak,

    Yes – once a symbol list has been created (either a manual list or linked to a .csv) then this can be used in any watchlist, scan, or backtest. Select it from the Lists tab:
    Capture

    #64627
    deepak
    • Topics: 50
    • Replies: 35
    • Posts: 85

    Yes sir this i understood however i want the list to fetch data from custom exchange and not optuma data is that possible.

    Regards,
    Deepak

    #64775
    Darren
    • Topics: 66
    • Replies: 617
    • Posts: 683

    Yes – click the Exchanges tab instead of Lists and the available exchanges will be available (including those that have been imported).

    #64777
    deepak
    • Topics: 50
    • Replies: 35
    • Posts: 85

    Sorry if there is any misunderstanding in my custom exchange there are many other symbols also which i don’t want so is there a way if i can select a manual list or a csv and apply to custom exchange.

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest