More precision in Tetrad tool

Optuma Forums Feature Requests More precision in Tetrad tool

This topic contains 0 replies, has 1 voice, and was last updated by  Peter 1 year, 7 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #28402

    Peter
    • Topics: 2
    • Replies: 0
    • Posts: 2

    I have another request regarding the Tetrad tool. I use this tool all the time to square the range. What I find is that if I try to align the initial vertical part of the tetrad it has a tendency to flip over and project into the past instead of into the future. Presumably some people use the tool in this way, although I can’t personally see a use for a backward projection. What it means in practice is that to ensure that the tool projects forward in time it is necessary to put a slight forward lead on it to ensure it doesn’t flip backwards. It means a loss of precision – not by a great deal admittedly but it can make me a couple of bars out on the time projection that I am attempting to anticipate. And it just looks a little scruffy also.

    Would it be possible to modify the tool so that I can always ensure a straight up and down angle on the initial side without the danger of it flipping to the reverse side? Maybe in the Properties panel there might be a tick box where each user could log their preferences for how the tool performs? Forwards or backwards… I am asking for more precision on the vertical alignment basically.  Thanks.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Pin It on Pinterest

Share This

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close