Option of not to include current signals results in signal tester

Optuma Forums Optuma Feature Requests Option of not to include current signals results in signal tester

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #65559
    Deepak
    • Topics: 61
    • Replies: 53
    • Posts: 114

    Dear Sir,

    Is it possible to give an option of not to include current signals result in signal tester. By this i mean lets say i am testing what happens post 21 days when close crosses above super trend 10.2. I run the test say from 01-01-2018 to 13-08-2021. Now suppose there was a signal on 10-08-2021 that will be included in current  result. Is it possible that an option is provided that it will exclude those signals which has not completed 21 days.

    Regards,
    Deepak

    #65569
    Mathew
    • Topics: 40
    • Replies: 1,997
    • Posts: 2,037

    Hi Deepak,

    There is no option for this.

    Only the portion that is valid is included in the results. So when you hover over the result line, you would see a higher number of “Values” contributing to the average at the start than you see at the end.

    All the best

    Mathew

    values

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest