PAG and ANR

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #58783
    AvatarAxel
    • Topics: 5
    • Replies: 5
    • Posts: 10

    Hi,

    is there an easier way in Optuma to do the following  is scripting the way to go?

    imagine there is a turning point w/ Venus then at 242 degrees. I can use the Angle Return tool that will show Venus at every 242 degrees. To show every 242 + say 45 degrees I am currently applying another Angle Return tool. And so for 245 + 45 + 45 degrees.

    The steps by degrees tool (Planetary angles ), I think, is based on the zero Aries. Or is there is a way to have it work from the position of your choice onwards ?

    Thank you,

    Axel

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Pin It on Pinterest

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close